E ONEQuest Ii
NHTSA vehicle recall lookup

2015 E One Quest Ii recalls

There are 5 NHTSA recall campaigns associated with this vehicle configuration.

Explore full safety analysis
Live source issuecomplaint data temporarily unavailable from NHTSA.
NHTSA recall campaigns5
NHTSA consumer complaintsUnavailable
Primary sourceNHTSA
Most-mentioned components
ELECTRICAL SYSTEM:STARTER ASSEMBLY · 2STEERING:LINKAGES:TIE ROD ASSEMBLY · 1SUSPENSION:FRONT · 1EQUIPMENT · 1
Campaign 19V730000

Electrical System › Starter Assembly

Feb 10, 2020
Summary

E-One Incorporated (E-One) is recalling certain 2013-2019 Typhoon and Cyclone 2, 2013-2014 Cyclone 3, 2014-2019 Quest 2 and 2017 CHSH emergency vehicles equipped with a Cummins ISL, L9, ISX12, X12, ISX15, or X15 engine. The engines do not have a diode in the starter solenoid circuit to improve the longevity of the lock-out relay, resulting in accumulated damage over time.

Risk

The damaged starter lock-out relay may prevent the vehicle from starting, hindering personnel from responding to emergencies, increasing the risk of an injury.

Remedy

E-One will notify owners, and dealers will install a diode in the starter solenoid circuit and install a new starter lock-out relay, free of charge. The recall began November 15, 2019. Owners may contact E-One customer service at 1-352-861-3612. Note: Vehicles previously repaired under recall 18V-019 also need this recall remedy.

Open campaign page →
Campaign 17V540000

Steering › Linkages › Tie Rod Assembly

Jul 8, 2019
Summary

E-One Incorporated (E-One) is recalling certain 2015 Cyclone II and Quest II emergency vehicles, equipped with certain Spicer D-Series and E-Series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.

Risk

If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering and increasing the risk of a crash.

Remedy

E-One will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on October 5, 2017. Owners may contact E-One customer service at 1-800-627-5050.

Open campaign page →
Campaign 18V171000

Suspension › Front

Mar 3, 2019
Summary

E-One Incorporated (E-One) is recalling certain 2008-2015 E-One Typhoon, Cyclone II, and Quest II vehicles, equipped with Timoney Independent Front Suspensions. Inconsistent machining may result in fatigue cracks developing over time in the front axle spindles, causing failure of the spindle and the possible separation of a front wheel from the vehicle.

Risk

A wheel separation from the vehicle can increase the risk of a crash.

Remedy

E-One will notify owners, and dealers will replace the front axle spindle, free of charge. The recall began on April 24, 2018. Owners may contact E-One customer service at 1-352-861-3612.

Open campaign page →
Campaign 18V019000

Electrical System › Starter Assembly

Sep 1, 2018
Summary

E-One Incorporated (E-One) is recalling certain 2013-2017 Cyclone II, Typhoon, and Quest II emergency vehicles equipped with a Cummins ISL, L9, ISX15, or X15 engine. The affected engines do not have a diode in the starter solenoid circuit to improve the longevity of the lock-out relay, resulting in accumulated damage over time.

Risk

The damaged starter lock-out relay may prevent the vehicle from starting, hindering personnel from responding to emergencies.

Remedy

E-One will notify owners, and dealers will install a diode in the starter solenoid circuit and install a new starter lock-out relay, free of charge. The recall began on February 19, 2018. Owners may contact E-One customer service at 1-352-861-3612.

Open campaign page →
Campaign 16V293000

Equipment

Dec 5, 2016
Summary

E-One Incorporated (E-One) is recalling certain model year 2015-2016 Cyclone II, Quest II and Typhoon emergency vehicles manufactured May 1, 2015, to March 31, 2016, equipped with pumps to provide pressurized water to aid in fighting fires. These pumps have 6" intake strainers that may have been improperly soldered during production and, as a result, the strainers may come apart during use, allowing parts of the strainer and debris to enter the pump, possibly damaging the pump.

Risk

If the strainer and/or debris enters the pump, and the operator is forced to shut down the pump, reducing firefighting effectiveness, there could be an increased risk of injury.

Remedy

E-One will notify owners to check the strainer for missing solder at the joints. Any strainers missing solder will be replaced, free of charge. The recall began on June 6, 2016. Owners may contact E-One customer service at 1-352-861-3612 or Hale customer service at 1-800-533-3569.

Open campaign page →

Does this mean my vehicle has an open recall?

No. Year/make/model results show campaigns associated with this vehicle configuration. RecallSight can decode your VIN and build the research dossier here; NHTSA remains authoritative for whether a specific VIN has an unrepaired recall.

Check a VIN on RecallSight →

What should I do?

Review the remedy and manufacturer guidance for each campaign. Safety recall remedies are generally provided by manufacturers without charge when the vehicle is covered.

Model history

See every E One Quest Ii model year

Browse all official vPIC model years, including years RecallSight has not indexed yet, then compare the evidence as each year is loaded.

Open E One Quest Ii model history →
Continue