2008 Farber Specialty Vehicle recalls

FARBER SPECIALTY IS RECALLING 32 MY 2005-2008 COMMERCIAL MOBILE COMMAND SPECIALTY VEHICLES BUILT ON WORKHORSE, FREIGHTLINER, CHEVROLET, FORD, UTILIMASTER AND WINNEBAGO CHASSIS AND EQUIPPED WITH RICON PLATFORM STYLE WHEELCHAIR LIFTS. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 404, "PLATFORM LIFT INSTALLATIONS IN MOTOR VEHICLES." THE THRESHOLD WARNING SYSTEM MAY NOT DETECT THE PRESENCE OF A WHEELCHAIR OR MOBILITY AID USER IN A CERTAIN SPOT WITHIN THE DEFINED THRESHOLD AREA.

THE USER OF THE LIFT COULD BE INJURED SHOULD THE LIFT MOVE UNINTENTIONALLY.

FARBER SPECIALTY IS WORKING WITH RICON TO CORRECT THE WHEELCHAIR LIFTS FREE OF CHARGE (PLEASE SEE 07E095). OWNERS MAY CONTACT RICON AT 1-818-267-3000 OR FARBER SPECIALTY AT 1-818-267-3016.

DAIMLER TRUCKS IS RECALLING 2,506 MY 2008 XC MOTOR HOME CHASSIS AND THOMAS BUILT HDX SCHOOL AND TRANSIT BUSES EQUIPPED WITH SAF-HOLLAND ADL SERIES REAR SUSPENSIONS. IN SOME INSTANCES THE TRANSVERSE BEAM WAS NOT PROPERLY WELDED WHICH COULD RESULT IN A FAILURE OF THE WELD.

IF THE WELD FAILS, VEHICLE STABILITY WHILE CORNERING COULD BE AFFECTED RESULTING IN LOSS OF VEHICLE CONTROL, POSSIBLY RESULTING IN A CRASH. IN ADDITION, THE TRANSVERSE BEAM COULD DROP TO THE GROUND CAUSING SPARKS THAT COULD CAUSE A FIRE HAZARD.

DAIMLER TRUCKS IS WORKING WITH SAF-HOLLAND TO HAVE A VISUAL INSPECTION OF THE ADL TRANSVERSE BEAM PERFORMED. IF A WELD DEFECT IS IDENTIFIED, SAF-HOLLAND WILL PROVIDE A SERVICE REPLACEMENT KIT THAT CONTAINS A NEW TRANSVERSE BEAM, ALL NECESSARY INSTALLATION HARDWARE, BEAM REPLACEMENT, AND INSTRUCTIONS FREE OF CHARGE (PLEASE SEE 08E031). THE RECALL RECALL BEGAN ON SEPTEMBER 12, 2008 (THOMAS BUILT BUSES) AND OCTOBER 8, 2008. OWNERS MAY CONTACT SAF-HOLLAND AT 1-231-773-3271 OR DAIMLER TRUCKS AT 1-800-547-0712.

FARBER SPECIALTY IS RECALLING 32 MY 2005-2008 COMMERCIAL MOBILE COMMAND SPECIALTY VEHICLES BUILT ON WORKHORSE, FREIGHTLINER, CHEVROLET, FORD, UTILIMASTER AND WINNEBAGO CHASSIS AND EQUIPPED WITH RICON PLATFORM STYLE WHEELCHAIR LIFTS. THESE LIFTS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 403, "PLATFORM LIFT SYSTEMS FOR MOTOR VEHICLES." THE ANTI-STOW INTERLOCK MAY NOT DETECT THE PRESENCE OF A WHEELCHAIR OR MOBILITY AID USER. THE PRESSURE SENSING SWITCH THAT DETECTS THE PRESENCE OF WEIGHT ON THE PLATFORM WAS NOT ADJUSTED TO THE NECESSARY SENSITIVITY LEVEL. THE LIFT COULD STOW EVEN THOUGH SOMEONE OR SOMETHING IS STILL ON THE LIFT.

A LIFT OCCUPANT CAN BE INJURED SHOULD THE LIFT BEGIN TO STOW UNINTENTIONALLY.

FARBER SPECIALTY IS WORKING WITH RICON TO CORRECT THE WHEELCHAIR LIFTS FREE OF CHARGE (PLEASE SEE 07E097). OWNERS MAY CONTACT RICON AT 1-818-267-3000 OR FARBER SPECIALTY AT 1-614-863-6470.

FARBER SPECIALTY VEHICLES (FSV) IS RECALLING CERTAIN MODEL YEAR 2008 THROUGH 2010 FSV SPECIALTY VEHICLES MANUFACTURED BETWEEN OCTOBER 2007 AND DECEMBER 2009 AND FITTED WITH CERTAIN RICON S SERIES AND K SERIES L-MODEL WHEELCHAIR LIFTS. DUE TO A PROBLEM IN THE SOFTWARE THAT CONTROLS THE LIFT'S "UP" FUNCTION, SHOULD THE "UP" BUTTON BE RELEASED BEFORE THE FLOOR LEVEL LIMIT SWITCH IS ACTIVATED, THE LIFT MAY CONTINUE ITS UPWARD TRAVEL AND MAY OVERRUN THE FLOOR LEVEL CUT OFF POINT.

WHEN THE PLATFORM OVERRUNS THE VEHICLE FLOOR LEVEL AND STOPS AT AN ANGLE FROM 15-20 DEGREES, IT IS POSSIBLE FOR A PERSON IN A WHEELCHAIR TO TIP OVER AND FOR SOMEONE STANDING ON THE PLATFORM TO FALL, POSSIBLY RESULTING IN INJURIES.

FSV WILL NOTIFY OWNERS AND THE REPAIRS WILL BE PERFORMED BY AUTHORIZED RICON DEALERS FREE OF CHARGE. A SOFTWARE SOLUTION FOR THIS SAFETY DEFECT IS UNDER INVESTIGATION. UNTIL THE SOFTWARE SOLUTION IS AVAILABLE, RICON WILL PROVIDE OWNERS WITH A BULLETIN OUTLINING PROPER WHEELCHAIR LIFT OPERATION AND WILL SHIP OWNERS A DVD-BASED TRAINING AID TO PROMOTE PROPER LIFT OPERATION AT NO COST. THE SAFETY RECALL BEGAN ON APRIL 20, 2010. OWNERS MAY CONTACT RICON AT 1-818-267-3000 OR FSV AT 1-614-863-6470.

FARBER SPECIALITY VEHICLES (FSV) IS RECALLING CERTAIN MODEL YEAR 2008-2010 FSV SPEACILITY VEHICLES MANUFACTURED BETWEEN DECEMBER 17, 2007 AND DECEMBER 18, 2009 AND FITTED WITH RICON PUBLIC USE LIFTS. THE RESTRAINT BELT ON THESE LIFTS WAS DESIGNED TO PREVENT THE LIFT FROM MOVING, UNLESS THE TONGUE OF THE BELT IS FULLY ENGAGED AND LATCHED IN THE BUCKLE. RICON HAS DISCOVERED, HOWEVER, THAT IT IS POSSIBLE FOR THE OPERATOR TO INSERT THE BELT TONGUE INTO THE BUCKLE WITHOUT FULLY ENGAGING THE LATCHING MECHANISM. IN THIS CASE, THE RESTRAINT BELT WOULD APPEAR TO BE LATCHED, AND THE OPERATOR COULD RUN THE LIFT. IF THE RESTRAINT BELT TONGUE IS NOT FULLY ENGAGED INTO THE RESTRAINT BELT BUCKLE, AND LATCHED, THE LIFT MAY OPERATE WITH AN OCCUPANT ON THE PLATFORM.

THE USER OF THE LIFT COULD BE INJURED SHOULD THE LIFT MOVE WITHOUT THE RESTRAINT BELT PROPERLY BUCKLED.

FSV IS WORKING WITH RICON AND RICON WILL BE PERFORMING THE REMEDY FOR THIS CAMPAIGN. PLEASE SEE RICON'S DEFECT REPORT 09E-060. RICON WILL PROVIDE CUSTOMERS WITH A WARNING DECAL AND A DVD-BASED TRAINING AID. THE SAFETY RECALL BEGAN ON APRIL 20, 2010. OWNERS MAY CONTACT RICON AT 1-818-267-3000 OR FSV AT 1-614-863-6470.