1995 Volvo Wg recalls

CERTAIN HEAVY DUTY CLASS 8 TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE TWO TAIL LAMPS, BACK-UP LAMP,AND LICENSE TAG LAMP WERE MOUNTED ON INSUFFICIENTLY RIGID MOUNTS.

IT MAY NOT ALLOW THE DRIVER OF A REARWARD APPROACHING VEHICLE TO HAVE FULL VIEW OF THE LAMPS.

DEALERS WILL ATTACH THE TWO TAIL LAMPS, BACK-UP LAMP, AND THE LICENSE TAP LAMP ON STIFFER BRACKETS. OWNER NOTIFICATION BEGAN OCTOBER 31, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VOLVO TRUCKS AT 1-800-528-6586.

THE TRACTION SOLENOID EXHAUST CAN BE OBSTRUCTED DUE TO INADEQUATE DRAINAGE AND A BUILD-UP OF ROAD CONTAMINATION BETWEEN THE MOUNTING BRACKET AND THE SOLENOID HOUSING. THE OBSTRUCTED EXHAUST PREVENTS THE RELAY VALVE CONTROL AIR PRESSURE FROM VENTING AFTER A DIFFERENTIAL BRAKING TRACTION EVENT.

THIS CONDITION WOULD KEEP THE REAR AXLE SERVICE BRAKES APPLIED WITHOUT ANY BRAKE PEDAL MOVEMENT BY THE DRIVER INCREASING THE RISK OF A VEHICLE ACCIDENT.

DEALERS WILL REMOVE THE SUSPECT VALVE AND INSTALL A NEW VALVE THAT HAS A MODIFIED SOLENOID HOUSING WHICH WILL ALLOW FOR SUFFICIENT DRAINAGE AND A NEW VALVE MOUNTING BRACKET WITH INCREASED HEIGHT TO REDUCE ENTRY OF CONTAMINATION.

THE REAR SUSPENSION AXLE RETENTION PLATE CAN BREAK UNDER NORMAL USE, AFFECTING AXLE ALIGNMENT.

THIS CONDITION COULD RESULT IN LOSS OF REAR AXLE STABILITY AFFECTING VEHICLE DIRECTIONAL CONTROL AND INCREASING THE POTENTIAL FOR A VEHICLE CRASH.

DEALERS WILL REMOVE AND REPLACE THE AXLE RETENTION CLIP PLATES ON AFFECTED VEHICLES.

UNDERCOATING APPLIED TO THE INSIDE OF THE CAB SHELL SQUEEZED OUT DURING ASSEMBLY ONTO THE BRAKE PEDAL PLUNGER.

UNDERCOATING ON THE PLUNGER MAY CAUSE THE PLUNGER TO STICK RESULTING IN INCREASED BRAKE PEDAL EFFORT AND/OR SLOW RELEASE OF THE BRAKES INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

DEALERS WILL CLEAN THE UNDERCOATING FROM THE BRAKE PEDAL PLUNGER ASSEMBLY, LUBRICATE AND REINSTALL THE BRAKE PEDAL PLUNGER ASSEMBLY.

VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE AIR SUSPENSION CONTROL VALVE SUPPLY LINE WAS NOT PLUMBED THROUGH AN AIR PRESSURE PROTECTION VALVE. IN THE EVENT OF A FAILURE, THERE WOULD BE LOSS OF AIR PRESSURE IN THE 'B' SYSTEM AIR RESERVOIR THAT SUPPLIES AIR PRESSURE FOR THE FRONT STEER AXLE BRAKES.

THIS CONDITION WOULD RESULT IN INCREASED STOPPING DISTANCES.

DEALERS WILL INSTALL THE NECESSARY AIR PRESSURE PROTECTION VALVE.

THE REAR MOST AXLE OF THE TANDEM AXLE SET COULD HAVE INOPERABLE BRAKES ON ONE OR BOTH WHEELS BECAUSE THE BRAKE S-CAM WAS INCORRECTLY INSTALLED.

THIS CONDITION COULD CAUSE INCREASED STOPPING DISTANCE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

DEALERS WILL INSPECT THE BRAKE SYSTEM AND REPAIR THE S-CAM ASSEMBLY IF FOUND REVERSED.