1984 CHEVROLET CAMARO recalls

CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.

HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).

PARKING BRAKE ADJUSTER FAILS TO OPERATE AND DO NOT WORK AFTER BRAKE PAD WEAR.

PARKING BRAKES WILL NOT COMPLETELY HOLD A PARKED VEHICLEWHEN PARKED ON A SLOPE, CAUSING UNINTENDED VEHICLE ROLLAWAY WHICH COULD RESULTIN A VEHICLE ACCIDENT.

REPLACE NONFUNCTIONING PARKING BRAKE ADJUSTERS.

PLASTIC COMPONENTS OF SEAT BELT BUCKLE ASSEMBLIES DO NOT CONTAIN AN ULTRA VIOLET STABILIZER, AND EXPOSURE TO DIRECT SUNLIGHT AND ELEVATED INTERIOR TEMPERATURES COULD WEAKEN THE PLASTIC COMPONENTS.

THIS COULD RESULT IN BREAKAGE OF PLASTIC COMPONENTS WHICHCOULD PREVENT BUCKLE FROM LATCHING AND PROTECTING OCCUPANT IN A SUDDEN STOP ORACCIDENT.

REPLACE OR REPAIR SEAT BELT BUCKLE.

REAR BRAKE HOSES WERE NOT PROPERLY MANUFACTURED AND DO NOT CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 106, "BRAKE HOSES". HOSES COULD COME LOOSE FROM THE END FITTINGS WHEN SUBJECTED TO A PULLING FORCE.

A NEW HOSE WILL BE INSTALLED IF NECESSARY. IN ADDITION, BRAKES WILL BE SERVICED.

SOME VEHICLES HAVE BUCKET SEAT BACK LOCKS THAT DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, ANCHORAGE OF SEATS. IN EVENT OF A CRASH, THE SEAT BACK LOCK MAY NOT FUNCTION.

INSPECTION OF SEAT BACK LOCKS WILL BE PERFORMED. LOCKS THAT HAVE BENT, BROKEN OR MISSING HOOKS WILL BE REPLACED.

DISLOCATION OF A SPRING COVER WILL NOT ALLOW THE SHOULDER BELT TO RETRACT AFTER BEING EXTENDED. CONSEQUENCE OF DEFECT: ALTHOUGH INERTIAL FEATURE THAT LOCKS THE LAP BELT AND SHOULDER BELT IN THE EVENT OF AN ACCIDENT ARE NOT AFFECTED, IF SLACK IS MORE THAN RECOMMENDED IN OWNERS MANUAL, INJURIES TO UPPER BODY AND HEAD WOULD BE INCREASED IN AN ACCIDENT.

INSTALL RETAINING SPRINGS ON SPRING COVER OF FRONT SHOULDER BELT RETRACTOR AND, WHEN REQUIRED, RETRACTORS WILL BE REPLACED.