1983 Ford F800 recalls
There are 2 NHTSA recall campaigns associated with this vehicle configuration.
Suspension › Front › Springs › Coil Springs
TWO-INCH SPACERS SPECIFIED FOR INSTALLATION BETWEEN THE FRONT AXLES AND EACH FRONT SPRING ASSEMBLY WERE OMITTED DURING MANUFACTURE. UNDER CERTAIN TURNING AND BOUNCING CONDITIONS, A FRONT TIRE COULD CONTACT ADJACENT VEHICLE COMPONENTS, RESULTING IN A POSSIBLE SEPARATION OF THE DRAG LINK TO STEERING ARM BALLJOINT OR LOSS OF TIRE PRESSURE.
FRONT AXLE SPACERS WILL BE INSTALLED WITHOUT CHARGE.
Electrical System › Wiring
ON THE AFFECTED VEHICLES, THE WIRING ASSEMBLY TO THE FLOOR MOUNTED HEADLAMP DIMMER SWITCH MAY BE TOO TIGHT; SHOULD WIRES DISCONNECT, THE HEADLIGHTS WILL NOT OPERATE.
THE DEALER WILL MODIFY THE DIMMER SWITCH WIRING WITH A WIRE EXTENSION ASSEMBLY AT NO CHARGE TO OWNER.
Does this mean my vehicle has an open recall?
No. Year/make/model results show campaigns associated with this vehicle configuration. RecallSight can decode your VIN and build the research dossier here; NHTSA remains authoritative for whether a specific VIN has an unrepaired recall.
Check a VIN on RecallSight →What should I do?
Review the remedy and manufacturer guidance for each campaign. Safety recall remedies are generally provided by manufacturers without charge when the vehicle is covered.
See every Ford F800 model year
Browse all official vPIC model years, including years RecallSight has not indexed yet, then compare the evidence as each year is loaded.