1979 FORD LTD recalls

INTERCONTINENTAL AUTO PARTS IS RECALLING 1,937 FUEL FILTERS, P/NOS ALG 44/1 AND PUROLATOR F10024, SHIPPED BETWEEN JANUARY 14 AND FEBRUARY 13, 2008, SOLD FOR USE ON THE VEHICLES LISTED ABOVE. THE FILTER'S OUTLET CAP MAY NOT BE SECURELY CRIMPED TO THE HOUSING. THIS COULD RESULT IN A SEPARATION OF FILTER'S OUTLET CAP FROM THE HOUSING.

IF THIS CONDITION OCCURS WHILE ATTEMPTING TO START THE VEHICLE, A NO START CONDITION MAY RESULT AND FUEL MAY BE PUMPED ONTO THE GROUND. IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION, THE ENGINE MAY STOP DUE TO INADEQUATE FUEL SUPPLY. IF AN IGNITION SOURCE WERE PRESENT, FUEL LEAKAGE MAY RESULT IN A FIRE.

INTERCONTINENTAL WILL REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING MARCH 2008. OWNERS MAY CONTACT INTERCONTINENTAL AT 800-451-2593.

ONE OR MORE OF THE FIVE COOLING FAN BLADES MAY HAVE BEEN IMPROPERLY RIVETED TO THE FAN SPIDER. THIS COULD ALLOW THE BLADES TO SEPARATE FROM THE FAN DURING ENGINE OPERATION.

DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE ENGINE COOLING FAN, WITHOUT CHARGE.

THE LOWER STEERING SHAFT ASSEMBLIES CONTAIN COUPLING RIVET PINS WHICH WERE NOT RIVETED SECURELY ENOUGH DURING MANUFACTURE. CONSEQUENTLY ONE OR BOTH OF THE PINS COULD LOOSEN FROM THE FLANGE OF THE FLEXIBLE COUPLING DURING VEHICLE OPERATION. IF ONE PIN IS LOOSE, FREE PLAY WOULD RESULT. IF BOTH PINS WORK LOOSE, LOSS OF STEERING CONTROL WOULD OCCUR. ALSO, THE SHAFT ASSEMBLY MAY NOT CONTAIN A METAL REINFORCEMENT BETWEEN ONE OR BOTH OF THE RIVET PINS AND THE RUBBER FLEXIBLE COUPLING. AS A RESULT, THE RUBBER FLEXIBLE COUPLING COULD TEAR AND PRODUCE A NOISE OR LOOSE FEELING IN THE STEERING SYSTEM.

THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE STEERING SHAFT ASSEMBLY, WITHOUT CHARGE TO OWNER.

DEALER WILL INSPECT AND, IF NECESSARY, INSTALL PROTECTIVE SHIELDS ON THE REBOUND BUMPER BRACKETS WITHOUT CHARGE TO OWNER.

THE WINDSHIELD WIPER AND WASHER SYSTEM CONTAINS AN INCORRECT 6 AMP CIRCUIT BREAKER INSTEAD OF THE 8.25 AMP CIRCUIT BREAKER. IF THE SYSTEM IS HEAVILY LOADED, AS IN THE CASE OF A PARTIALLY DRY WINDSHIELD, THE MOTOR CURRENT MAY EXCEED THE 6 AMP BREAKER"S CAPACITY. THIS WOULD CAUSE THE BREAKER TO OPEN, WHICH WOULD RESULT IN WIPER/WASHER FAILURE.

DEALER WILL INSTALL THE CORRECT CIRCUIT BREAKER WITHOUT CHARGE TO OWNER.

THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.

SOME VEHICLES WERE PRODUCED WITH BRAKE CONTROL VALVES AND BRAKE TUBES INTENDED FOR USE IN VEHICLES WITHOUT TRAILER TOW PACKAGES.

DEALER WILL REPLACE BRAKE CONTROL VALVE AND CONNECTING BRAKE TUBE.

SOME OF THESE VEHICLES WERE PRODUCED WITH MISINDEXED FRONT BRAKE HOSES WHICH COULD CONTACT A TIRE OR WHEEL IN A FULL-TURN CONDITION. CHAFING AND WEAR TO THE BRAKE HOSE COULD RESULT IN LOSS OF BRAKE FLUID AND FRONT WHEEL BRAKING CAPABILITY.

DEALER WILL INSPECT AND, IF NECESSARY, RE-INDEX THE FRONT BRAKE HOSE. THOSE HOSES SHOWING SIGNS OF ABRASION WILL BE REPLACED, WITHOUT CHARGE TO OWNER.

THE WORD "LIGHTS" WAS OMITTED FROM THE PANEL APPLIQUE IDENTIFYING THE HEADLAMP SWITCH. WITHOUT THIS IDENTIFICATION THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 101, "CONTROLS AND DISPLAYS".

OWNERS OF THE AFFECTED VEHICLES WILL BE MAILED ADHESIVE BACKED LABELS CONTAINING THE WORD "LIGHTS", ALONG WITH INSTRUCTIONS FOR PROPER INSTALLATION AT NO CHARGE.